Digital Printing
Screen Printing
Metallic Gold – 92 ICC Plastisol Ink
₱952.00
FEATURES
- 92 Metallic Gold is used to produce a “gilded” metallic look when printed.
- 92 Metallic Gold produces the best look when directly printed onto a garment or fabric.
- Designs made with 92 Metallic Gold may be applied to light or dark fabrics.
RECOMMENDED FABRICS 100% Cotton Some 50/50 Cotton/Polyester Blends INK APPLICATION 92 Metallic Gold should be used right from the container without any modificaitons. Stir well prior to each use. ADDITIVES Not recommended. SCREEN MESH 74-160 t/in (30-63 t/cm) monofilament EMULSION Any direct or indirect emulsion or capillary film in the 35 to 70 micron range SQUEEGEE 65-75 Durometer Sharp edge CURE TEMPERATURES 325°F (163°C) entire ink film CLEAN-UP Any eco-friendly plastisol screen wash STORAGE OF INK CONTAINERS 65º to 90ºF (18ºC to 32ºC) Avoid storage in direct sunlight Keep containers well sealed
2 in stock
SPOT FLASHING
This product will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift off, but not totally fused. Totally fusing the underprint may cause inter-coat adhesion problems with the inks printed on top. Final fusing or curing will occur in the in the dryer. Failure to fuse ink properly may cause cracking, poor adhesion and poor wash fastness.
IMPORTANT INFORMATION
Caution: 92 Metallic Gold contains a high loading of uncoated metallic powders that will tarnish (turn gray) when exposed to any type of detergent or water that contains a bleaching or whitening agent. The abrasion resistance of this ink is low. There will be some rub-off of metallic particles even when the ink is properly cured/fused. It is extremely important to preprint and test printed fabrics for wash and wear durability before beginning production.
92 Metallic Gold reflects infrared heat. A forced air dryer is highly recommended for proper curing/fusion of these products. Complete fusion of these products may be very difficult to achieve in an infrared dryer. Even when the 92 Metallic Gold is properly fused, there will be some rub off of metallic particles. Check for proper cure/fusion of product by wash testing finished product according to the wash instructions below.
To obtain best wash results, make sure printed inks are properly cured/fused and hand wash with a phosphate free detergent such as Woolite®, then air or line dry. Do not use bleach, iron or dry clean the printed garment.
Air drying washed product is strongly recommended. Dulling of ink surface may be caused by heat and abrasion in a clothes dryer.
Garments printed with 92 Metallic Gold should be labeled with recommended washing instructions. It is recommended to use 157 Gold shimmer when best overall wash and wear durability is desired for metallic looking prints.
Related products
Screen Printing Inks
₱840.00
Screen Printing Inks
₱896.00
Screen Printing Inks
₱672.00
Screen Printing Inks
₱811.00
Out of stock
Screen Printing Inks
₱784.00
Out of stock
Screen Printing Inks
₱138.00
Out of stock
Other Screen Printing Consumables
₱56.00
Screen Printing Consumables
₱795.20