Fluorescent Magenta Ultramix ICC Plastisol Ink

FEATURES

• UltraMix® 7500 Series Pantone® Color System consists of 19 non-phthalate, high performance colors, formulated for ultra high speed wet-on-wet automatic printing.
• Create special or standard colors by using International Coatings’ UltraMix®, Pantone® color matching software, either online or on the desktop version.
• Well suited for fine detail and halftone printing using finer mesh counts.
• The 7500 Series inks will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift-off, but not totally fused. Total fusing of any flashed color may cause inter-coat adhesion problems with the inks printed on top of the flashed ink. Final fusing or curing should occur in the dryer.

RECOMMENDED FABRICS
100% Cotton
50/50 Cotton/Polyester Blends

INK APPLICATION
7500 Series Colors should only be
used with other 7500 Series
Colors, without any modifications

ADDITIVES
If modification is necessary, use
1% to 5% by weight of 1099 Low
Bleed Curable Reducer

SCREEN MESH
110-305 t/in (43-120 t/cm)
monofilament

EMULSION
Any direct or indirect emulsion or
capillary film in the 35 to 70
micron range

SQUEEGEE
65-70 Durometer
Sharp edge

CURE TEMPERATURES
325°F (163°C) entire ink film

CLEAN-UP
Any eco-friendly plastisol
screen wash

STORAGE OF INK CONTAINERS
65º to 90ºF (18ºC to 32ºC)
Avoid storage in direct sunlight
Keep containers well sealed